This week I was able to drive the car a bit down the street again, fun stuff!
I finally grounded my coolant temp gauge so that now
works. That allowed me to run the engine
at a high idle and build some heat, too much heat really. I kept it running till the gauge was almost
to the red zone and shut it down, I wanted to see if the fan would kick on but
no-go. I need to revisit that system
before I can take the car on the road.
Other wiring issues I've been dealing with are the wires
that send power from the old voltage regulator to the old fuse box. The problem is the regulator isn’t used
anymore, so I needed to tap into another source of power for the fuse box. Simple in concept really, just took some
work. I have that done so now I have
brake lights, parking lights etc.
Something is still mis-wired behind the instrument cluster because my
fuel gauge only works when the high beams are on. I had those wires all labeled, but evidently
not well enough, only half of the labels are still legible. Oh well, it’s almost done.
Next I’ll need to track down a problem with the brakes,
they are firm in the garage but with the engine running they take a pump of
the pedal before they work. Something
isn’t right, maybe the brakes are
backing off somehow with the vibration of the engine.
 |
| Dash apart again. |
 |
| My new jumper wire. THIS TIME I'm using a fuse inline. No more smoke in the car with a wire glowing bright orange... |
No comments:
Post a Comment
Fell free to post any questions and I'll do my best to help you out with your project.